Bagmont soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bagmont shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bagmont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bagmont spot on the map
Rated from the USDA soil survey record for Bagmont gravelly loam, 40 to 90 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly ashy loam layer about 0 to 4 in down: about 13% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A very gravelly ashy fine sandy loam layer about 4 to 12 in down: about 13% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH3best layer A very gravelly fine sandy loam layer about 12 to 38 in down: about 8% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- BedrockH4 Weathered bedrock about 38 to 48 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 12 to 38 in down in the typical profile: yellowish brown (10YR 5/4), dark brown (10YR 4/3) moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and volcanic ash mixed with colluvium and residuum derived from schist and gneiss.
- USDA family particle-size class: ashy-skeletal.
- Drainage: well drained.
- Paralithic bedrock typically about 38 in (96 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: Central Washington. The series is of small extent.
USDA, geographic setting: Bagmont soils are on back slopes of mountains. They formed in loess and volcanic ash mixed with colluvium and residuum from schist and gneiss. Slopes are 40 to 90 percent. Elevation is 4,800 to 5,800 feet. Climate is characterized by cool, dry summers and cold, moist winters, the average January temperature is 24 degrees F, the average July temperature is 68 degrees F, and the average annual air temperature is 41 to 43 degrees F. The average annual precipitation is 25 to 30 inches. The frost-free season is 80 to 110 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Bagmont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bagmont gravelly loam, 40 to 90 percent slopes, map unit 35 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Bagmont(revised 07/1999), established.
- Taxonomic class: Ashy-skeletal, glassy Humic Xeric Vitricryands
- Rated with rule version 2026-09-28.1; the method is on the About page.