Azwell soil
Wild-clay potential
Weak indication
Weak indication: no layer of Azwell shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Azwell soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Azwell-Rock outcrop complex, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 11% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 29% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A stony ashy loam layer about 0 to 4 in down: about 13% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2best layer A cobbly ashy loam layer about 4 to 15 in down: about 11% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH3 A very stony ashy fine sandy loam layer about 15 to 26 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 26 to 30 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 4 to 15 in down in the typical profile: dark grayish brown (10YR 4/2), dark brown (10YR 4/3) moist; soft, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium weathered from gneiss and schist mixed with volcanic ash.
- USDA family particle-size class: ashy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 26 in (66 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: North Central Washington. Series is of small extent.
USDA, geographic setting: Azwell soils are on back slopes of mountains that usually have a southerly aspect. Elevations are 4,000 to 6,500 feet. Slopes are 30 to 60 percent. Azwell soils formed in residuum and colluvium from gneiss and schist mixed with volcanic ash. The climate is characterized by warm, dry summers and cold, moist winter. The average annual precipitation is 30 to 50 inches. The mean January temperature is about 22 degrees F., the mean July temperature is about 60 degrees F., and the mean annual air temperature is 40 to 42 degrees F. The growing season at 28 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Azwell-Rock outcrop complex, 30 to 60 percent slopes, map unit 34 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Azwell(revised 11/2000), established.
- Taxonomic class: Ashy-skeletal, glassy Xeric Vitricryands
- Rated with rule version 2026-09-28.1; the method is on the About page.