Ashburn soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 8 to 26 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ashburn soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ashburn spot on the map
Rated from the USDA soil survey record for Ashburn silt loam, 2 to 7 percent slopes (Fauquier County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 29% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 8 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH2best layer A silty clay loam layer about 8 to 26 in down: about 29% clay, high plasticity when wet, yellowish brown when moist. Promising
- Loamy layerH3 A channery silty clay loam layer about 26 to 39 in down: about 29% clay, high plasticity when wet, yellowish red when moist. Possible
- BedrockH4 Bedrock about 39 to 49 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 8 to 26 in down in the typical profile: yellowish brown (10YR 5/6); firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: reworked alluvium over residuum weathered from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
- Lithic bedrock typically about 39 in (99 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Fauquier County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Virginia and possibly Maryland and Pennsylvania. The series is of small extent.
USDA, geographic setting: Ashburn soils are on broad, convex interfluves in the Culpeper Basin of the northern Piedmont. These soils formed in reworked alluvium and the underlying red Triassic interbedded siltstone, fine-grained sandstone, and shale residuum. Slopes range from 0 to 8 percent. The mean annual air temperature ranges from 49 to 57 degrees F. Mean annual precipitation ranges from 35 to 45 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Fletcherville: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
See it on the map
Open a Ashburn spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ashburn silt loam, 2 to 7 percent slopes, map unit 74B in Fauquier County, Virginia.
- Official Series Description: Ashburn(revised 11/2005), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Oxyaquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.