Ardenmont soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ardenmont shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ardenmont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ardenmont spot on the map
Rated from the USDA soil survey record for Ardenmont coarse sandy loam, 8 to 30 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Note Moderate engineering plasticity index (7.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 28 in (72 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 27% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 An ashy coarse sandy loam layer about 0 to 4 in down: about 8% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerH2 An ashy coarse sandy loam layer about 4 to 23 in down: about 12% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH3best layer A gravelly loamy coarse sand layer about 23 to 51 in down: about 12% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- BedrockH4 Weathered bedrock about 51 to 61 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 23 to 51 in down in the typical profile: light yellowish brown (10YR 6/4), yellowish brown (10YR 5/4) moist; hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium weathered from schist mixed with volcanic ash and loess.
- USDA family particle-size class: sandy.
- Drainage: well drained.
- Paralithic bedrock typically about 51 in (130 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: East-Central Chelan County, Washington; MLRA 6. The series is of small extent.
USDA, geographic setting: Ardenmont soils are on mountain side slopes. Elevation is 2,200 to 4,700 feet. Slopes are 8 to 90 percent. These soils formed in residuum and colluvium derived mainly from schist mixed with ash and loess in the surface. They are in a climate with warm, dry summers and cool, moist winters. The mean annual precipitation is 18 to 24 inches. The mean annual January temperature is about 24 degrees F. and the mean July temperature is about 64 degrees F. The mean annual temperature is 41 to 44 degrees F. The growing season at 28 degrees F.is 120 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Ardenmont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ardenmont coarse sandy loam, 8 to 30 percent slopes, map unit 28 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Ardenmont(revised 07/2004), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Vitrandic Haploxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.