Ardening soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ardening shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ardening soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ardening spot on the map
Rated from the USDA soil survey record for Ardening stony loam, 30 to 60 percent slopes (Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Note Moderate engineering plasticity index (7.5).
- Note The official series description calls the wet soil nonsticky and slightly plastic.
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 27% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A stony loam layer about 0 to 6 in down: about 13% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2 A gravelly loam layer about 6 to 18 in down: about 14% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerH3 A cobbly loam layer about 18 to 26 in down: about 14% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerH4best layer A cobbly loam layer about 26 to 42 in down: about 14% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- BedrockH5 Weathered bedrock about 42 to 52 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H4), 26 to 42 in down in the typical profile: pale brown (10YR 6/3), dark brown (10YR 4/3) moist; slightly hard, friable, nonsticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum and colluvium weathered mainly from schist mixed with loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 42 in (107 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
By state: wild clay in Washington.
USDA, distribution and extent: Central Chelan County, Washington. The series is of small extent.
USDA, geographic setting: Ardening soils are on mountainsides that usually have a southerly aspect. Elevation is 2,600 to 4,500 feet. Slopes are 30 to 65 percent. These soils formed in residuum and colluvium derived mainly from schist mixed with ash and loess in the surface. They are in a climate with warm, dry summers and cool, moist winters. The average annual precipitation is 20 to 35 inches. The mean annual January temperature is about 24 degrees F. The mean July temperature is about 69 degrees F. The growing season at 28 degrees is about 130 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bjork: Promising
- Cle Elum: Promising
- Cowiche: Possible
- Dragoon: Possible
- Georgecreek: Possible
- Kingmont: Possible
- Loneridge: Possible
- Morical: Possible
See it on the map
Open a Ardening spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ardening stony loam, 30 to 60 percent slopes, map unit 27 in Cashmere Mountain Area, Washington, Parts of Chelan and Okanogan Counties.
- Official Series Description: Ardening(revised 10/2002), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.