Westlake soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 21 to 49 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Westlake soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Westlake spot on the map
Rated from the USDA soil survey record for Westlake-Latahco complex, 0 to 3 percent slopes (Lewis and Nez Perce Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (18).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 23% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- TopsoilA A silt loam layer about 10 to 21 in down: about 23% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Loamy layerCg1best layer A silt loam layer about 21 to 49 in down: about 27% clay, moderate plasticity when wet, gray when moist. Possible
- Loamy layerCg2 A silt loam layer about 49 to 64 in down: about 26% clay, moderate plasticity when wet, gray when moist. Weak indication
What it looks like raw
The loamy layer (Cg1), 21 to 49 in down in the typical profile: gray (10YR 5/1), very dark gray (10YR 3/1) moist; hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium and/or loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Latah County, Idaho; Lewis and Nez Perce Counties, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Northern Idaho. The series is of small extent.
USDA, geographic setting: Westlake soils are on flood plains and drainageways and have gradients of 0 to 3 percent. They formed in alluvium primarily from loess. Elevation is 2,500 to 4,200 feet. The average annual precipitation is about 21 to 26 inches. The average annual temperature is 43 to 45 degrees F. The frost free season is about 90 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Driscoll: Strong lead
- Garfield: Strong lead
- Latah: Strong lead
- Taney: Strong lead
- Tilma: Strong lead
- Latahco: Promising
- Naff: Promising
See it on the map
Open a Westlake spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Westlake-Latahco complex, 0 to 3 percent slopes, map unit 151 in Lewis and Nez Perce Counties, Idaho.
- Official Series Description: Westlake(revised 10/2002), established.
- Taxonomic class: Fine-silty, mixed, superactive, frigid Cumulic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.