Wenonah soil
Wild-clay potential
Weak indication
Weak indication: no layer of Wenonah shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wenonah soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Wenonah spot on the map
Rated from the USDA soil survey record for Wenonah silt loam (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 12% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw1 A silt loam layer about 10 to 20 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw2 A very fine sandy loam layer about 20 to 32 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerC1best layer A fine sandy loam layer about 32 to 60 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC2 A very fine sandy loam layer about 60 to 72 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (C1), 32 to 60 in down in the typical profile: brown (10YR 5/3); fine sandy loam with lenses of silt loam; very friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium derived from glacial drift containing mainly sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New York, in these survey areas: Delaware County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Wenonah soils are in central and southern New York. MLRA 101 and 140. The series is of moderate extent.
USDA, geographic setting: Wenonah soils are nearly level soils on flood plains including high bottoms. Slope ranges from 0 to 3 percent. The soils formed in post glacial alluvium derived from glacial drift having a high content of sandstone, siltstone and shale. Mean annual temperature ranges from 46 to 51 degrees F., mean annual precipitation ranges from 35 to 48 inches, and the mean annual frost-free season ranges from 120 to 170 days. The elevation of these soils is 200 to 1500 feet.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Bucksport: Weak indication
- Carlisle: Weak indication
- Chenango: Weak indication
- Deposit: Weak indication
- Elka: Weak indication
See it on the map
Open a Wenonah spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wenonah silt loam, map unit Wg in Delaware County, New York.
- Official Series Description: Wenonah(revised 03/2007), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Fluventic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.