Watt soil
Wild-clay potential
Weak indication
Weak indication: no layer of Watt shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Watt soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Watt channery silt loam, 15 to 35 percent slopes (Spotsylvania County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 16 in (40 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Loamy layerH1 A channery silt loam layer about 0 to 7 in down: about 19% clay, low plasticity when wet, dark olive gray when moist. Weak indication
- Loamy layerH2 A channery silt loam layer about 7 to 16 in down: about 25% clay, moderate plasticity when wet, olive gray when moist. Weak indication
- Sandy layerH3best layer A very channery silt loam layer about 16 to 32 in down: about 16% clay, low plasticity when wet, black when moist. Weak indication
- BedrockH4 Bedrock about 32 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 16 to 32 in down in the typical profile: black (5Y 2/1), streaked with olive gray (5Y 4/2), and olive yellow (2.5Y 6/8); firm. Raw colour is not fired colour.
About the soil
- Parent material: graphitic residuum weathered from schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 32 in (81 cm) down.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Virginia, in these survey areas: Prince William County, Virginia; Spotsylvania County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern and north-central Piedmont Plateau of Virginia, possibly Maryland and Pennsylvania. The series is of small extent.
USDA, geographic setting: Watt soils are on upland ridges and narrow sideslopes in the Piedmont Plateau. Slopes are dominately 7 to 25 percent but range from 2 to 60 percent. These soils developed in a regolith weathered from black graphitic rock. The average annual temperature ranges from 51 F to 59 degrees F. The average annual precipitation ranges from 40 to 44 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Caroline: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Orange: Strong lead
- Susquehanna: Strong lead
- Turbeville: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Watt channery silt loam, 15 to 35 percent slopes, map unit 47E in Spotsylvania County, Virginia.
- Official Series Description: Watt(revised 03/2022), established.
- Taxonomic class: Loamy-skeletal, mixed, semiactive, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.