Wanship soil
Wild-clay potential
Weak indication
Weak indication: no layer of Wanship shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Wanship soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Wanship spot on the map
Rated from the USDA soil survey record for Wanship-Kovich loams, 0 to 3 percent slopes (Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 75% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA1 A loam layer about 0 to 8 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilA2 A loam layer about 8 to 14 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilA3 A loam layer about 14 to 24 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layer2C1 An extremely cobbly loamy sand layer about 24 to 26 in down: about 3% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layer2C2best layer An extremely cobbly loamy sand layer about 26 to 60 in down: about 3% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (2C2), 26 to 60 in down in the typical profile: brown (10YR 4/3), pale brown (10YR 6/3) dry; loose. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from sandstone and conglomerate.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy over sandy or sandy-skeletal.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
By state: wild clay in Utah.
USDA, distribution and extent: North Central Utah. LRR E, MLRA 47. This series is of small extent.
USDA, geographic setting: Parent material: Alluvium derived from sandstone and conglomerate.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Manila: Strong lead
- Fewkes: Promising
- Hades: Promising
- Harter: Promising
- Ayoub: Possible
- Dastrup: Possible
- Echocreek: Possible
- Richsum: Possible
See it on the map
Open a Wanship spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Wanship-Kovich loams, 0 to 3 percent slopes, map unit 179 in Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
- Official Series Description: Wanship(revised 08/2000), established.
- Taxonomic class: Fine-loamy over sandy or sandy-skeletal, mixed, superactive, frigid Aquic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.