Richsum soil
Wild-clay potential
Possible
Possible: a surface layer with some clay typically about 2 to 14 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Richsum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Richsum spot on the map
Rated from the USDA soil survey record for Richsum-Heiners complex, 15 to 30 percent slopes (Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
- Note Surface layer; expect roots and organic matter.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A silt loam layer about 0 to 2 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- TopsoilA2best layer A silt loam layer about 2 to 14 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Possible
- Loamy layerBk1 A silt loam layer about 14 to 23 in down: about 23% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Loamy layerBk2 A silt loam layer about 23 to 32 in down: about 23% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Loamy layerB3 A gravelly silt loam layer about 32 to 52 in down: about 23% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- BedrockCr Bedrock about 52 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The topsoil (A2), 2 to 14 in down in the typical profile: dark brown (7.5YR 3/4), brown (7.5YR 5/4) dry; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium and colluvium derived from sandstone, conglomerate and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 52 in (132 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
By state: wild clay in Utah.
USDA, distribution and extent: High tablelands and low mountains of north central Utah. The series is moderately extensive. MLRA 47.
USDA, geographic setting: Richsum soils are on high tablelands, low mountains and valley sides at elevations of 5,600 to 7,400 feet. They formed in residuum, slope alluvium, and valley side alluvium derived from shale, sandstone and conglomerate. Slopes range from 4 to 60 percent. Aspects are mainly south, southwest. Average annual precipitation is 14 to 16 inches and mean annual temperature is 40 to 45 degrees F. The freeze-free period is 60 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Manila: Strong lead
- Fewkes: Promising
- Hades: Promising
- Harter: Promising
- Ayoub: Possible
- Dastrup: Possible
- Echocreek: Possible
- Yeates Hollow: Possible
See it on the map
Open a Richsum spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Richsum-Heiners complex, 15 to 30 percent slopes, map unit 163 in Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
- Official Series Description: Richsum(revised 07/1999), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Typic Calcixerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.