Harter soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 33 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Harter soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Harter gravelly loam, 2 to 15 percent slopes (Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (37.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts about 33 in (84 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 20% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA1 A gravelly loam layer about 0 to 5 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilA2 A gravelly loam layer about 5 to 12 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilAB A gravelly loam layer about 12 to 19 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay subsoilBt1 A gravelly clay loam layer about 19 to 24 in down: about 38% clay, high plasticity when wet, brown when moist. Possible
- Clay subsoilBt2 A gravelly clay layer about 24 to 33 in down: about 38% clay, high plasticity when wet, reddish brown when moist. Promising
- Clay subsoilBt3best layer A gravelly clay layer about 33 to 60 in down: about 48% clay, high plasticity when wet, reddish brown when moist. Promising
What it looks like raw
The clay subsoil (Bt3), 33 to 60 in down in the typical profile: reddish brown (5YR 4/4), light reddish brown (5YR 6/4) dry; extremely hard, very firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
By state: wild clay in Utah.
USDA, distribution and extent: Mountain areas of north-central Utah. The series is moderately extensive. MLRA 47.
USDA, geographic setting: Harter soils are on fan remnants, footslopes, and mountain slopes. Slope gradients range from 2to 40 percent. Elevations range from 5,700 to 8,000 feet. The average annual precipitation is 16 to 22 inches. The mean annual air temperature is 40 to 45 degrees F. and the freeze-free period is 60 to 90 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Manila: Strong lead
- Fewkes: Promising
- Hades: Promising
- Ayoub: Possible
- Dastrup: Possible
- Echocreek: Possible
- Richsum: Possible
- Yeates Hollow: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Harter gravelly loam, 2 to 15 percent slopes, map unit 139 in Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
- Official Series Description: Harter(revised 11/1999), established.
- Taxonomic class: Fine, smectitic, frigid Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.