Vickery soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 17 to 34 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Vickery soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Vickery spot on the map
Rated from the USDA soil survey record for Vickery-Marsing silt loams, 1 to 3 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (13).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA A silt loam layer about 0 to 4 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerBw A silt loam layer about 4 to 17 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Loamy layerBkbest layer A loam layer about 17 to 34 in down: about 20% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Bkqm A cemented material layer about 34 to 47 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layer2C A coarse sand layer about 47 to 60 in down: about 7% clay, low plasticity when wet. Weak indication
What it looks like raw
The loamy layer (Bk), 17 to 34 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and/or volcanic ash and/or alluvium derived from igneous rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. The series is of large extent.
USDA, geographic setting: Vickery soils are on level to rolling dissected very high terraces, calderas, buttes, and plains. Elevations range form 2,000 to 5,100 feet. Slopes are commonly less than 5 percent and range from 0 to 15 percent. These soils formed in a thin mantle of loess and alluvium from igneous rocks and very minor amounts of volcanic ash overlying medium to coarse textured alluvial material. The climate is semiarid and summers are dry. The average annual precipitation is 8 to 12 inches, including 1 to 3 feet of snow. The average annual temperature is 45 to 52 degrees F. The frost-free period is 100 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Catherine: Promising
- Elijah: Promising
- Greenleaf: Promising
- Nannyton: Promising
- Baldock: Possible
- Chance: Possible
- Draper: Possible
- Harpt: Possible
See it on the map
Open a Vickery spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Vickery-Marsing silt loams, 1 to 3 percent slopes, map unit VmB in Canyon Area, Idaho.
- Official Series Description: Vickery(revised 04/2001), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Xeric Haplodurids
- Rated with rule version 2026-09-28.1; the method is on the About page.