Twomile soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 26 to 79 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Twomile soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Twomile spot on the map
Rated from the USDA soil survey record for Twomile silt loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Missouri) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 33% clay in the fine-earth portion.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (23): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 53 in (134 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 9 in down: about 14% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerE A silt layer about 9 to 15 in down: about 11% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerExg A silt loam layer about 15 to 26 in down: about 13% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Clay subsoilBtgbest layer A silty clay loam layer about 26 to 79 in down: about 33% clay, high plasticity when wet, grayish brown when moist. Promising
What it looks like raw
The clay subsoil (Btg), 26 to 79 in down in the typical profile: grayish brown (2.5Y 5/2); silty clay loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Illinois, Missouri, in these survey areas: Pike County, Illinois; Pike County, Missouri.
By state: wild clay in Illinois,wild clay in Missouri.
USDA, distribution and extent: Missouri and west-central Illinois. These have large extent.
USDA, geographic setting: Twomile soils are on high flood plains and have slope gradients of 0 to 2 percent. They formed in loess or loess and alluvium. Mean annual temperature ranges from 51 to 57 degrees F, and mean annual precipitation ranges from 33 to 43 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Keswick: Strong lead
- Bremer: Strong lead
- Bucklick: Strong lead
- Carlow: Strong lead
- Chequest: Strong lead
- Crider: Strong lead
- Darwin: Strong lead
- Dupo: Strong lead
See it on the map
Open a Twomile spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 92%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Twomile silt loam, 0 to 2 percent slopes, occasionally flooded, map unit 56003 in Pike County, Missouri.
- Official Series Description: Twomile(revised 08/2000), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Typic Albaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.