Templeton soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 28 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Templeton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Templeton spot on the map
Rated from the USDA soil survey record for Templeton medial silt loam, 3 to 30 percent slopes (Clatsop County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 34% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- TopsoilA A medial silt loam layer about 2 to 15 in down: about 23% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Loamy layerBw1 A silty clay loam layer about 15 to 28 in down: about 31% clay, moderate plasticity when wet, reddish brown when moist. Promising
- Loamy layerBw2best layer A silty clay loam layer about 28 to 43 in down: about 34% clay, high plasticity when wet, yellowish red when moist. Promising
- Loamy layerBw3 A silty clay loam layer about 43 to 54 in down: about 34% clay, high plasticity when wet, light brown when moist. Promising
- Loamy layerBw4 A paragravelly silty clay loam layer about 54 to 59 in down: about 34% clay, high plasticity when wet, reddish brown when moist. Weak indication
- BedrockCr Weathered bedrock about 59 to 69 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (Bw2), 28 to 43 in down in the typical profile: yellowish red (5YR 5/6), light brown (7.5YR 6/4) dry; hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum derived from sedimentary rock.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
- Paralithic bedrock typically about 59 in (150 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Clatsop County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Western slopes of the Coast Range in Oregon; MLRA 4A. The series is extensive.
USDA, geographic setting: Templeton soils are benches, broad ridgetops, and side slopes of mountains. These soils formed in colluvium and residuum weathered from sedimentary rocks. Elevations are 50 to 1,800 feet. Slopes are 0 to 90 percent. The marine climate is cool and wet in the winter and cool and moist with a short dry season of less than 45 consecutive days during the summer. The mean annual precipitation is 60 to 110 inches. The mean annual temperature is 45 to 53 degrees F. The mean January temperature is 42 to 46 degrees F. and the mean July temperature is 58 to 62 degrees F. The frost-free season is 100 to 245 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Brenner: Strong lead
- Chitwood: Strong lead
- Grindbrook: Strong lead
- Hebo: Strong lead
- Coquille: Promising
- Ecola: Promising
- Knappa: Promising
- Nestucca: Promising
See it on the map
Open a Templeton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Templeton medial silt loam, 3 to 30 percent slopes, map unit 60D in Clatsop County, Oregon.
- Official Series Description: Templeton(revised 06/2011), established.
- Taxonomic class: Fine-silty, isotic, isomesic Andic Humudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.