Brenner soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 45 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brenner soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Brenner spot on the map
Rated from the USDA soil survey record for Brenner silt loam, 0 to 3 percent slopes (Clatsop County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 39% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts about 45 in (114 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 24% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerH2 A silty clay loam layer about 10 to 45 in down: about 24% clay, moderate plasticity when wet, very dark gray when moist. Possible
- Clay-rich layerH3best layer A silty clay loam layer about 45 to 60 in down: about 39% clay, moderate plasticity when wet, greenish black when moist. Strong lead
What it looks like raw
The clay-rich layer (H3), 45 to 60 in down in the typical profile: greenish black (10Y 2.5/1), very dark gray (10YR 3/1) dry; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Clatsop County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Flood plains of coastal river valleys in Western Oregon; MLRA 4a. The series is moderately extensive.
USDA, geographic setting: The Brenner soils are in swales on flood plains adjacent to stream terraces. Slopes are 0 to 3 percent. Elevations range from 10 to 700 feet. The soils formed in silty mixed recent alluvium derived from basic igneous and sedimentary rocks. Water ponds in winter after heavy rains or when streams overflow leaving thin layers of fresh alluvium on the surface. The soils are characterized by cool wet winters and cool moist summers with fog. The mean annual precipitation is 60 to 100 inches. The average January temperature is 38 to 45 degrees F. and the average July temperature is 58 to 64 degrees F. The mean annual temperature is 48 to 53 degrees F. The frost-free season is 160 to 300 days....
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chitwood: Strong lead
- Grindbrook: Strong lead
- Hebo: Strong lead
- Coquille: Promising
- Ecola: Promising
- Knappa: Promising
- Nestucca: Promising
- Templeton: Promising
See it on the map
Open a Brenner spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brenner silt loam, 0 to 3 percent slopes, map unit 8A in Clatsop County, Oregon.
- Official Series Description: Brenner(revised 11/2004), established.
- Taxonomic class: Fine-silty, mixed, superactive, acid, isomesic Fluvaquentic Humaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.