Svensen soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 41 to 63 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Svensen soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Svensen spot on the map
Rated from the USDA soil survey record for Svensen loam, 3 to 30 percent slopes (Clatsop County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts about 41 in (104 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 3 in down, not a clay body. Weak indication
- Sandy layerH1 A loam layer about 3 to 20 in down: about 18% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerH2 A loam layer about 20 to 41 in down: about 25% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH3best layer A fine sandy loam layer about 41 to 63 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Possible
What it looks like raw
The loamy layer (H3), 41 to 63 in down in the typical profile: and light brownish gray (10YR 6/2), strong brown (7.5YR 5/6), reddish yellow (7.5YR 6/6), very pale brown (10YR 7/3) dry; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Oregon, in these survey areas: Clatsop County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Fog belt areas of the Coast Range Mountains, Oregon; MLRA 4A. The series is of moderate extent.
USDA, geographic setting: Svensen soils are on ridgetops, side slopes, and foot slopes of mountains. Elevations are 20 to 1,300 feet. Slopes are 0 to 90 percent. The soils formed in colluvium and residuum weathered from dominantly from sandstone with some areas of metasedimentary or metavolcanic origin. The climate is characterized by cool wet winters and cool moist summers. Many summer days have fog or low cloud cover during the morning. The mean annual precipitation 60 to 100 inches. The mean annual temperature is 45 to 53 degrees F. The frost-free period is 145 to 270 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Brenner: Strong lead
- Chitwood: Strong lead
- Grindbrook: Strong lead
- Hebo: Strong lead
- Coquille: Promising
- Ecola: Promising
- Knappa: Promising
- Nestucca: Promising
See it on the map
Open a Svensen spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Svensen loam, 3 to 30 percent slopes, map unit 59D in Clatsop County, Oregon.
- Official Series Description: Svensen(revised 06/2011), established.
- Taxonomic class: Fine-loamy, isotic, isomesic Andic Humudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.