Poindexter soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 6 to 19 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Poindexter soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Poindexter spot on the map
Rated from the USDA soil survey record for Poindexter loam, 7 to 15 percent slopes (Spotsylvania County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- Sandy layerH1 A loam layer about 0 to 6 in down: about 18% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2best layer A clay loam layer about 6 to 19 in down: about 30% clay, moderate plasticity when wet, yellow when moist. Promising
- Loamy layerH3 A sandy clay loam layer about 19 to 27 in down: about 23% clay, moderate plasticity when wet, mottled strong brown when moist. Possible
- BedrockH4 Bedrock about 27 to 45 in down: no clay layer to dig. Weak indication
- BedrockH5 Bedrock about 45 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 6 to 19 in down in the typical profile: yellow (10YR 7/8); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed mafic residuum.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 45 in (114 cm) down.
Where it is mapped
Seen on the map as the most common soil in 8 map units in North Carolina, Virginia, in these survey areas: Davidson County, North Carolina; Spotsylvania County, Virginia.
By state: wild clay in North Carolina,wild clay in Virginia.
USDA, distribution and extent: Distribution: Georgia, North Carolina, South Carolina, and Virginia
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Armenia: Strong lead
- Badin: Strong lead
- Brockroad: Strong lead
- Casville: Strong lead
- Catharpin: Strong lead
- Clifford: Strong lead
See it on the map
Open a Poindexter spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Poindexter loam, 7 to 15 percent slopes, map unit 35C in Spotsylvania County, Virginia.
- Official Series Description: Poindexter(revised 06/2026), established.
- Taxonomic class: Fine-loamy, mixed, active, thermic Typic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.