Pinal soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pinal shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pinal soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pinal gravelly loam, 0 to 1 percent slopes (Eastern Maricopa and Northern Pinal Counties Area, Arizona) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 20% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note Surface layer; expect roots and organic matter.
- Note USDA reports about 20% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA/Bkbest layer A gravelly loam layer about 0 to 18 in down: about 22% clay, moderate plasticity when wet, light brown when moist. Weak indication
- Bqm A cemented material layer about 18 to 60 in down: USDA gives no clay percentage or texture for it. Not enough data
What it looks like raw
The topsoil (A/Bk), 0 to 18 in down in the typical profile: light brown (7.5YR 6/4), brown (7.5YR 4/4) moist; hard, friable, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: gravelly mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Arizona, in these survey areas: Eastern Maricopa and Northern Pinal Counties Area, Arizona.
By state: wild clay in Arizona.
USDA, distribution and extent: Southern Arizona. Pinal soils are moderately extensive. MLRA 40.
USDA, geographic setting: Pinal soils are on nearly level to moderately sloping old alluvial fans and terraces at elevations of 400 to 2,500 feet. Slope gradients range from 0 to 9 percent. The soils developed in medium-textured nongravelly or gravelly alluvium derived from mixed rock sources but mainly tuffs, rhyolite and volcanic ash. The climate is warm, arid, and continental. Mean annual temperature ranges from 67 degrees to 76 degrees F. and mean annual precipitation ranges from 3 to 10 inches. The frost-free season ranges from 250 to 350 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Avondale: Strong lead
- Contine: Strong lead
- Estrella: Promising
- Mohall: Promising
- Pimer: Promising
- Laveen: Possible
- Antho: Weak indication
- Gilman: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pinal gravelly loam, 0 to 1 percent slopes, map unit PnA in Eastern Maricopa and Northern Pinal Counties Area, Arizona.
- Official Series Description: Pinal(revised 01/2007), established.
- Taxonomic class: Loamy, mixed, superactive, hyperthermic, shallow Typic Haplodurids
- Rated with rule version 2026-09-28.1; the method is on the About page.