Palouse soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 27 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Palouse soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Palouse spot on the map
Rated from the USDA soil survey record for Palouse silt loam, 3 to 7 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts about 27 in (68 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 27 in down: about 21% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerH2best layer A silt loam layer about 27 to 60 in down: about 25% clay, moderate plasticity when wet, pale brown when moist. Possible
What it looks like raw
The loamy layer (H2), 27 to 60 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; hard, friable, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and some ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 12 map units in Idaho, Washington, in these survey areas: Latah County, Idaho; Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Southeastern Washington, northeastern Oregon, and northern Idaho. Series is extensive.
USDA, geographic setting: Palouse soils are on hills at elevations of 1,600 to 4,500 feet. Slopes are 0 to 60 percent. These soils formed in Late Wisconsin loess which contains some volcanic ash in the upper part. Summers are warm and dry; winters are cool and moist. The average annual precipitation ranges from 18 to 25 inches. Average January temperature is 27 to 30 degrees F, average July temperature is 67 to 70 degrees F. The mean annual temperature ranges from 46 to 51 degrees F. and on the average frost-free season is about 100 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Garfield: Strong lead
- Latah: Strong lead
- Tilma: Strong lead
- Cramont: Strong lead
- Driscoll: Strong lead
- Konert: Strong lead
- Taney: Strong lead
- Naff: Promising
See it on the map
Open a Palouse spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Palouse silt loam, 3 to 7 percent slopes, map unit 64 in Whitman County, Washington.
- Official Series Description: Palouse(revised 09/2013), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Pachic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.