Owyhee soil
Wild-clay potential
Weak indication
Weak indication: no layer of Owyhee shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Owyhee soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Owyhee silt loam, 0 to 2 percent slopes (Malheur County, Oregon, Northeastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (30 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 14% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBA A silt loam layer about 10 to 16 in down: about 14% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBkbest layer A silt loam layer about 16 to 28 in down: about 14% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layer2Bk A silt loam layer about 28 to 38 in down: about 14% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layer2C1 A very fine sandy loam layer about 38 to 50 in down: about 14% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layer2C2 A very fine sandy loam layer about 50 to 60 in down: about 14% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (Bk), 16 to 28 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Idaho, Oregon, in these survey areas: Canyon Area, Idaho; Malheur County, Oregon, Northeastern Part.
By state: wild clay in Idaho,wild clay in Oregon.
USDA, distribution and extent: Valleys in southwestern Idaho and eastern Oregon. The series is of moderate extent
USDA, geographic setting: The soils are in level to sloping undulating, or slightly depressed areas in low and medium terraces at elevations of 610 to 1370 meters. Slopes most commonly are less than 3 percent but range from 0 to 30 percent. The soils formed in moderately calcareous, laminated, medium textured, lacustrine material or old alluvium over these laminated sediments. The climate is semiarid and has dry summers. Average freeze-free period is 110 to 170 days, and average annual precipitation is 178 to 305 millimeters, including about 305 to 915 millimeters of snow. Average annual temperature is 9.5 to 11 degrees C.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Catherine: Promising
- Elijah: Promising
- Greenleaf: Promising
- McLoughlin: Promising
- Nannyton: Promising
- Baldock: Possible
- Chance: Possible
- Draper: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Owyhee silt loam, 0 to 2 percent slopes, map unit 25A in Malheur County, Oregon, Northeastern Part.
- Official Series Description: Owyhee(revised 03/2018), established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Xeric Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.