Murtip soil
Wild-clay potential
Weak indication
Weak indication: no layer of Murtip shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Murtip soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Murtip medial loam, 3 to 30 percent slopes (Clatsop County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA1 A medial loam layer about 1 to 7 in down: about 15% clay, low plasticity when wet, very dark brown when moist. Weak indication
- TopsoilA2 A medial loam layer about 7 to 14 in down: about 18% clay, low plasticity when wet, dark brown when moist. Weak indication
- Loamy layerBw1 A medial loam layer about 14 to 24 in down: about 22% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerBw2best layer A medial loam layer about 24 to 43 in down: about 24% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerBC A gravelly medial loam layer about 43 to 50 in down: about 22% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockCr Weathered bedrock about 50 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (Bw2), 24 to 43 in down in the typical profile: brown (7.5YR 4/4), yellowish brown (10YR 5/4) dry; slightly hard, friable, slightly sticky and slightly plastic; moderately smeary. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and resdiuum derived from igneous rock.
- USDA family particle-size class: medial.
- Drainage: well drained.
- Paralithic bedrock typically about 50 in (127 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Clatsop County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Northern and central portions of the Coast Range in Oregon; MLRA 1. The series is moderately extensive.
USDA, geographic setting: Murtip soils occur on summits, foot slopes and toe slopes of mountains. Elevations are 1,600 to 3,000 feet. Slopes are 3 to 90 percent. The soils formed in loamy colluvium and residuum derived from basalt or other igneous and volcanic rock types. The climate is characterized by cool wet winters and warm moist summers. The average annual precipitation is 80 to 200 inches. The average January temperature is about 28 degrees F., and the average July temperature is about 59 degrees F. The mean annual temperature is 42 to 46 degrees F. The frost-free period is 60 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Brenner: Strong lead
- Chitwood: Strong lead
- Grindbrook: Strong lead
- Hebo: Strong lead
- Coquille: Promising
- Ecola: Promising
- Knappa: Promising
- Nestucca: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Murtip medial loam, 3 to 30 percent slopes, map unit 46D in Clatsop County, Oregon.
- Official Series Description: Murtip(revised 07/2006), established.
- Taxonomic class: Medial, ferrihydritic, frigid Alic Hapludands
- Rated with rule version 2026-09-28.1; the method is on the About page.