Millicoma soil
Wild-clay potential
Weak indication
Weak indication: no layer of Millicoma shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Millicoma soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Millicoma spot on the map
Rated from the USDA soil survey record for Millicoma gravelly loam, 30 to 60 percent slopes (Clatsop County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 18% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Lowers the potential High rock content (about 49% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerH1 A gravelly loam layer about 2 to 17 in down: about 18% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2best layer A very gravelly loam layer about 17 to 40 in down: about 18% clay, low plasticity when wet, dark brown when moist. Weak indication
- BedrockH3 Weathered bedrock about 40 to 50 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 17 to 40 in down in the typical profile: dark brown (10YR 3/3), pale brown (10YR 6/3) dry; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived dominantly from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Paralithic bedrock typically about 40 in (101 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Clatsop County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: On the western slopes of the Coast range in Oregon; MLRA 4A. The series is extensive.
USDA, geographic setting: Millicoma soils have mountainous topography and are on ridges and side slopes with dominant gradients of 50 to 75 percent, but ranging from 10 to 90 percent. The soils formed dominantly in sandstone with some areas of metasedimentary or metavolcanic origin. Elevations are 50 to 1,600 feet. The climate is characterized by cool and wet winters and cool and moist summers. The mean annual precipitation is 60 to 100 inches. The mean annual temperature is 47 to 54 degrees F., mean January temperature is 42 to 46 degrees F., and the mean July temperature is 58 to 62 degrees F. The frost-free period is 100 to 270 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Brenner: Strong lead
- Chitwood: Strong lead
- Grindbrook: Strong lead
- Hebo: Strong lead
- Coquille: Promising
- Ecola: Promising
- Knappa: Promising
- Nestucca: Promising
See it on the map
Open a Millicoma spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Millicoma gravelly loam, 30 to 60 percent slopes, map unit 44E in Clatsop County, Oregon.
- Official Series Description: Millicoma(revised 06/2011), established.
- Taxonomic class: Loamy-skeletal, isotic, isomesic Andic Humudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.