Middlebrook soil
Wild-clay potential
Weak indication
Weak indication: no layer of Middlebrook shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Middlebrook soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Middlebrook spot on the map
Rated from the USDA soil survey record for Middlebrook-Mongaup complex, 2 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Note Moderate engineering plasticity index (7.5).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Lowers the potential High rock content (about 36% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A channery silt loam layer about 0 to 6 in down: about 12% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBw A channery silt loam layer about 6 to 17 in down: about 12% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerCBbest layer A very channery loam layer about 17 to 35 in down: about 12% clay, moderate plasticity when wet, brown when moist. Weak indication
- Bedrock2R Bedrock about 35 to 45 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (CB), 17 to 35 in down in the typical profile: brown (10YR 5/3), and pale brown (10YR 6/3); very channery loam; firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived from sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 35 in (89 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in New York, in these survey areas: Delaware County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Catskill Mountain area of east central New York, the southern tier of New York and possibly northeastern Pennsylvania. MLRA 140. The series is of small extent.
USDA, geographic setting: Middlebrook soils are nearly level to strongly sloping soils on bedrock controlled uplands, dominantly occurring on broad hilltops and in saddle positions. Slope ranges from 0 to 15 percent. These soils formed in till derived from sandstone, siltstone, and shale. The till forms a mantle 20 to 40 inches thick over the sandstone, siltstone, and shale bedrock from which it is derived. Mean annual temperature ranges from 43 to 45 degrees F.; mean annual precipitation ranges from 37 to 46 inches; and the mean frost-free season ranges from 100 to 130 days. The elevation ranges from 1750 to 2500 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Bucksport: Weak indication
- Carlisle: Weak indication
- Chenango: Weak indication
- Deposit: Weak indication
- Elka: Weak indication
See it on the map
Open a Middlebrook spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Middlebrook-Mongaup complex, 2 to 8 percent slopes, map unit MkB in Delaware County, New York.
- Official Series Description: Middlebrook(revised 04/2013), established.
- Taxonomic class: Coarse-loamy, mixed, active, frigid Aquic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.