Maplecrest soil
Wild-clay potential
Weak indication
Weak indication: no layer of Maplecrest shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Maplecrest soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Maplecrest spot on the map
Rated from the USDA soil survey record for Maplecrest gravelly silt loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (3.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts about 46 in (117 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A gravelly silt loam layer about 0 to 3 in down: about 12% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBA A gravelly silt loam layer about 3 to 6 in down: about 12% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBw1 A gravelly silt loam layer about 6 to 18 in down: about 12% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBw2 A gravelly very fine sandy loam layer about 18 to 36 in down: about 10% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerC1 A gravelly loam layer about 36 to 46 in down: about 12% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerC2best layer A gravelly fine sandy loam layer about 46 to 72 in down: about 10% clay, low plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 46 to 72 in down in the typical profile: reddish brown (5YR 5/3); friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy till dominated by material from reddish sandstone and siltstone or shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in New York, in these survey areas: Delaware County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Central-eastern New York State in the Catskill Mountains. MLRA 140. The series is of small extent.
USDA, geographic setting: Maplecrest soils are typically on complex slopes characteristic of end or lateral moraines or along lower valley side slopes where the processes of solifluction have resulted in accumulations of loose till material overlying stratified outwash or poorly sorted ice contact deposits. Slopes range from 3 to 60 percent in gradient. The till is dominated by material from reddish sandstone and siltstone or shale. Mean annual temperature ranges from 46 to 52 degrees F, annual precipitation from 47 to 52 inches and growing season from 120 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Bucksport: Weak indication
- Carlisle: Weak indication
- Chenango: Weak indication
- Deposit: Weak indication
- Elka: Weak indication
See it on the map
Open a Maplecrest spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Maplecrest gravelly silt loam, 3 to 8 percent slopes, map unit MaB in Delaware County, New York.
- Official Series Description: Maplecrest, established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.