Manor soil
Wild-clay potential
Weak indication
Weak indication: no layer of Manor shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Manor soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Manor silt loam, 6 to 15 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 4 in down: about 18% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 4 to 23 in down: about 18% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Sandy layerH3best layer A silt loam layer about 23 to 60 in down: about 13% clay, low plasticity when wet, variegated olive brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 23 to 60 in down in the typical profile: variegated olive brown (2.5Y 4/4), strong brown (7.5YR 5/6), pink (7.5YR 7/4); very friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from granite and gneiss.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 63 map units in Delaware, Maryland, Pennsylvania, Virginia, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Chester County, Pennsylvania; Delaware County, Pennsylvania; Harford County Area, Maryland; Lancaster County, Pennsylvania; Montgomery County, Pennsylvania; Philadelphia County, Pennsylvania; Prince William County, Virginia; Stafford and King George Counties, Virginia; and 2 more.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in Pennsylvania,wild clay in Virginia.
USDA, distribution and extent: Distribution: Maryland, Delaware, Pennsylvania, the District of Columbia, and Virginia
USDA, geographic setting: Landscape: Piedmont Plateau
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Jackland: Strong lead
- Worsham: Strong lead
- Albano: Strong lead
- Caroline: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Manor silt loam, 6 to 15 percent slopes, map unit MaD in Stafford and King George Counties, Virginia.
- Official Series Description: Manor(revised 08/2013), established.
- Taxonomic class: Coarse-loamy, micaceous, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.