Lolalita soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lolalita shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lolalita soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lolalita spot on the map
Rated from the USDA soil survey record for Lolalita coarse sandy loam, 30 to 55 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Note Moderate engineering plasticity index (7).
- Note The official series description calls the wet soil slightly sticky.
- Note Thick enough to investigate (about 31 in (78 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- TopsoilA A coarse sandy loam layer about 0 to 5 in down: about 12% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBwbest layer A coarse sandy loam layer about 5 to 36 in down: about 12% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerBk A loamy coarse sand layer about 36 to 60 in down: about 9% clay, low plasticity when wet, pale yellow when moist. Weak indication
What it looks like raw
The sandy layer (Bw), 5 to 36 in down in the typical profile: light yellowish brown (2.5Y 6/3), light olive brown (2.5Y 5/4) moist; slightly hard, very friable, slightly sticky. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits and/or alluvium and/or colluvium derived from igneous rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho and possibly southeastern Oregon. The series is of moderate extent.
USDA, geographic setting: The Lolalita soils are on level to very steep uplands and terraces at elevations of 2,000 to 4,500 feet. Many areas have south facing slopes. Slopes range from 0 to 75 percent. The soil formed chiefly in unconsolidated sediments from intrusive acid igneous rocks. The climate is semiarid and summers are dry. The average freeze-free period is 110 to 170 days, and the average annual precipitation is 8 to 12 inches, including 1 to 2.5 feet of snow.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Catherine: Promising
- Elijah: Promising
- Greenleaf: Promising
- Nannyton: Promising
- Baldock: Possible
- Chance: Possible
- Draper: Possible
- Harpt: Possible
See it on the map
Open a Lolalita spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lolalita coarse sandy loam, 30 to 55 percent slopes, map unit LuG in Canyon Area, Idaho.
- Official Series Description: Lolalita(revised 10/2002), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, nonacid, mesic Xeric Torriorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.