Locoda soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Locoda soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Locoda silt loam, 0 to 3 percent slopes (Clatsop County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 50 in (127 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 19% clay, low plasticity when wet, gray when moist. Weak indication
- Loamy layerH2best layer A stratified silt loam to silty clay loam layer about 10 to 60 in down: about 27% clay, moderate plasticity when wet, gray when moist. Possible
What it looks like raw
The loamy layer (H2), 10 to 60 in down in the typical profile: gray (5Y 5/1), few fine prominent strong brown (7.5YR 4/6); hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: recent silty alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Clatsop County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Northwestern Oregon along the Columbia River. The soil is inextensive.
USDA, geographic setting: Locoda soils are in nearly level or concave positions on flood plains. Slopes are 0 to 3 percent. Elevations range from 0 to 20 feet. The soils formed in recent silty alluvium. They are in a climate with warm moist summers and cool wet winters. The mean annual precipitation is 50 to 80 inches. Mean July temperature is 62 to 68 degrees F., mean January temperature is 36 to 40 degrees F., and mean annual temperature is 50 to 54 degrees F. The frost-free period is 165 to 210 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Brenner: Strong lead
- Chitwood: Strong lead
- Grindbrook: Strong lead
- Hebo: Strong lead
- Coquille: Promising
- Ecola: Promising
- Knappa: Promising
- Nestucca: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Locoda silt loam, 0 to 3 percent slopes, map unit 39A in Clatsop County, Oregon.
- Official Series Description: Locoda(revised 06/2005), established.
- Taxonomic class: Fine-silty, mixed, superactive, acid, mesic Typic Fluvaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.