Leyden soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 3 to 35 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Leyden soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Leyden-Primen-Standley cobbly clay loams, 15 to 50 percent slopes (Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts within about 3 in (8 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A cobbly clay loam layer about 0 to 3 in down: about 31% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A gravelly clay layer about 3 to 35 in down: about 48% clay, high plasticity when wet, brown when moist. Promising
- BedrockH3 Weathered bedrock about 35 to 39 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 3 to 35 in down in the typical profile: brown (10YR 4/3), dark brown (10YR 3/3) moist; hard, firm, sticky. Raw colour is not fired colour.
About the soil
- Parent material: calcareous, gravelly, cobbly, stony, and clayey slope alluvium over residuum weathered from mudstone.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 35 in (89 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Colorado, in these survey areas: Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
By state: wild clay in Colorado.
USDA, distribution and extent: Leyden soils are of small extent in the foothills along the eastern front of the Rocky Mountains in central Colorado; MLRA 49.
USDA, geographic setting: Landform - side slopes and ridges, and dip slopes of hogbacks and homoclinal ridges
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Manzanola: Strong lead
- Nunn: Strong lead
- Platner: Strong lead
- Samsil: Strong lead
- Ulm: Strong lead
- Valmont: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 35%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Leyden-Primen-Standley cobbly clay loams, 15 to 50 percent slopes, map unit 80 in Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
- Official Series Description: Leyden(revised 05/2023), established.
- Taxonomic class: Fine, smectitic, mesic Aridic Argiustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.