Lewbeach soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lewbeach shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lewbeach soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lewbeach spot on the map
Rated from the USDA soil survey record for Lewbeach channery loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (9).
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A channery loam layer about 0 to 7 in down: about 15% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBw1 A channery loam layer about 7 to 17 in down: about 15% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBw2 A channery loam layer about 17 to 26 in down: about 14% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerBxbest layer A channery loam layer about 26 to 60 in down: about 15% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerC A very channery loam layer about 60 to 72 in down: about 13% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The sandy layer (Bx), 26 to 60 in down in the typical profile: reddish brown (5YR 4/3); very firm; brittle. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived mainly from reddish sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in New York, in these survey areas: Delaware County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Higher elevations of MLRA 140. The series is moderately extensive.
USDA, geographic setting: Lewbeach soils are gently sloping to very steep soils on glaciated uplands. Slope ranges from 3 to 55 percent. The soils developed in very firm, acid till high in sandstone with a smaller component of red shale. The climate is humid and is cool in summer and cold in winter. Annual air temperature ranges from 4 to 9 degrees C (39 to 48 degrees F). Annual precipitation ranges from 825 to 1790 mm (32 to 70 in) and the frost free days range from 110 to 155 days. Elevation ranges from 425 to 1100 m (1394 to 3608 ft) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Bucksport: Weak indication
- Carlisle: Weak indication
- Chenango: Weak indication
- Deposit: Weak indication
- Elka: Weak indication
See it on the map
Open a Lewbeach spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lewbeach channery loam, 3 to 8 percent slopes, map unit LhB in Delaware County, New York.
- Official Series Description: Lewbeach(revised 09/2015), established.
- Taxonomic class: Coarse-loamy, mixed, semiactive, frigid Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.