Legault soil
Wild-clay potential
Weak indication
Weak indication: no layer of Legault shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Legault soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Legault spot on the map
Rated from the USDA soil survey record for Legault-Hiwan stony loamy sands, 15 to 30 percent slopes (Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 12 in (30 cm)).
- Note Typically starts within about 1 in (3 cm) of the surface.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly loamy sand layer about 0 to 1 in down: about 5% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2best layer A very gravelly loamy sand layer about 1 to 13 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
- BedrockH3 Weathered bedrock about 13 to 17 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 1 to 13 in down in the typical profile: light gray (10YR 7/2), grayish brown (10YR 5/2) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: acidic, gravelly, stony, and sandy residuum weathered from igneous and metamorphic rock.
- USDA family particle-size class: sandy-skeletal.
- Drainage: somewhat excessively drained.
- Paralithic bedrock typically about 13 in (33 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Colorado, in these survey areas: Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
By state: wild clay in Colorado.
USDA, distribution and extent: Mountainous areas of north central Colorado. LRR E; MLRA 48A. This series is of moderate extent.
USDA, geographic setting: Parent material: slope alluvium, colluvium, and residuum from schist, gneiss, and granitic rocks
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Manzanola: Strong lead
- Nunn: Strong lead
- Platner: Strong lead
- Samsil: Strong lead
- Ulm: Strong lead
- Valmont: Strong lead
See it on the map
Open a Legault spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Legault-Hiwan stony loamy sands, 15 to 30 percent slopes, map unit 76 in Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
- Official Series Description: Legault(revised 07/2010), established.
- Taxonomic class: Sandy-skeletal, micaceous, shallow Typic Cryorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.