Hardtrigger soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 3 to 21 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hardtrigger soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hardtrigger spot on the map
Rated from the USDA soil survey record for Hardtrigger-Briabbit-Tindahay complex, 1 to 15 percent slopes (Owyhee County Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Btk" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 18 in (45 cm)).
- Note Typically starts within about 3 in (8 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 19% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A gravelly sandy loam layer about 0 to 3 in down: about 16% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Clay subsoilBtkbest layer A gravelly sandy clay loam layer about 3 to 21 in down: about 28% clay, high plasticity when wet, very pale brown when moist. Possible
- Sandy layerBk A gravelly coarse sandy loam layer about 21 to 49 in down: about 15% clay, moderate plasticity when wet, white when moist. Weak indication
- Sandy layerBkq A very gravelly loamy sand layer about 49 to 60 in down: about 8% clay, low plasticity when wet, white when moist. Weak indication
What it looks like raw
The clay subsoil (Btk), 3 to 21 in down in the typical profile: very pale brown (10YR 7/4), light yellowish brown (10YR 6/4) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Idaho, in these survey areas: Owyhee County Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. Hardtrigger soils are of moderate extent. MLRA 25.
USDA, geographic setting: Hardtrigger soils are gently sloping to moderately steep on fan terraces, calderas and structural benches at elevations of 2,350 to 5,400 feet. Slopes range from 1 to 35 percent. These soils formed in mixed alluvium from volcaniclastic materials. The climate is cool and moist in the winter and hot and dry in the summer. Average annual precipitation ranges from 8 to 13 inches. Average annual temperature ranges from 45 to 52 degrees F. Frost-free period is 90 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Fairylawn: Strong lead
- Perla: Strong lead
- Ratsnest: Strong lead
- Succor: Strong lead
- Arbidge: Promising
- Babbington: Promising
- Gooding: Promising
See it on the map
Open a Hardtrigger spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hardtrigger-Briabbit-Tindahay complex, 1 to 15 percent slopes, map unit 69 in Owyhee County Area, Idaho.
- Official Series Description: Hardtrigger(revised 01/2019), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Xeric Haplargids
- Rated with rule version 2026-09-28.1; the method is on the About page.