Halcott soil
Wild-clay potential
Weak indication
Weak indication: no layer of Halcott shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Halcott soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Halcott spot on the map
Rated from the USDA soil survey record for Halcott, Mongaup, and Vly soils, 2 to 15 percent slopes, very rocky (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Bedrock or unweathered rock, not a soil layer to dig for clay.
Layer by layer
- TopsoilA A channery loam layer about 0 to 3 in down: about 12% clay, low plasticity when wet, dusky red when moist. Weak indication
- Sandy layerBw A very channery silt loam layer about 3 to 11 in down: about 12% clay, low plasticity when wet. Weak indication
- Sandy layerBC A very channery silt loam layer about 11 to 18 in down: about 12% clay, low plasticity when wet. Weak indication
- Bedrock2Rbest layer Bedrock about 18 to 28 in down: no clay layer to dig. Weak indication
What it looks like raw
The bedrock (2R), 18 to 28 in down in the typical profile: dusky red (2.5YR 3/4); thinly bedded sandstone. Raw colour is not fired colour.
About the soil
- Parent material: a thin mantle of channery, loamy till derived from reddish sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 18 in (46 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in New York, in these survey areas: Delaware County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Central-eastern New York State at higher elevations in the Catskill Mountains. MLRA 140. The series is extensive with an estimated 250,000 acres.
USDA, geographic setting: Halcott soils are on nearly level to very steep uplands. Slopes range from 0 to 70 percent. They formed in a thin mantle of till derived from reddish, acid sandstone, siltstone and shale. Mean annual temperature ranges from 40 to 49 degrees F. The mean annual precipitation ranges from 47 to 60 inches. The growing season is 90 to 110 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Bucksport: Weak indication
- Carlisle: Weak indication
- Chenango: Weak indication
- Deposit: Weak indication
- Elka: Weak indication
See it on the map
Open a Halcott spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 27%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Halcott, Mongaup, and Vly soils, 2 to 15 percent slopes, very rocky, map unit HcC in Delaware County, New York.
- Official Series Description: Halcott(revised 04/1999), established.
- Taxonomic class: Loamy-skeletal, mixed, active, frigid Lithic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.