Galestown soil
Wild-clay potential
Weak indication
Weak indication: no layer of Galestown shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Galestown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Galestown spot on the map
Rated from the USDA soil survey record for Galestown-Sassafras complex, 6 to 15 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 72 in (183 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- Sandy layerH1 A loamy fine sand layer about 0 to 12 in down: about 8% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2best layer A loamy fine sand layer about 12 to 84 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH3 A fine sand layer about 84 to 99 in down: about 4% clay, low plasticity when wet. Weak indication
What it looks like raw
The sandy layer (H2), 12 to 84 in down in the typical profile: yellowish brown (10YR 5/6); very friable; nonsticky; nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy marine deposits.
- USDA family mineralogy: siliceous.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 10 map units in District of Columbia, Maryland, Virginia, in these survey areas: Baltimore County, Maryland; Charles County, Maryland; District of Columbia; Prince George's County, Maryland; Stafford and King George Counties, Virginia.
By state: wild clay in District of Columbia,wild clay in Maryland,wild clay in Virginia.
USDA, distribution and extent: Distribution: Coastal Plain areas of Maryland, Delaware, New Jersey
USDA, geographic setting: Landscape: Coastal Plain Upland,
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Appling: Strong lead
- Benevola: Strong lead
- Bladen: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
See it on the map
Open a Galestown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Galestown-Sassafras complex, 6 to 15 percent slopes, map unit GsD in Stafford and King George Counties, Virginia.
- Official Series Description: Galestown(revised 11/2015), established.
- Taxonomic class: Siliceous, mesic Psammentic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.