Flaskan soil
Wild-clay potential
Promising
Promising: a surface layer with some clay typically about 18 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Flaskan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Flaskan spot on the map
Rated from the USDA soil survey record for Flaskan sandy clay loam, 0 to 2 percent slopes (Santa Clara Area, California, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (19).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (30 cm)).
- Note Typically starts within about 18 in (45 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilAp A sandy clay loam layer about 0 to 5 in down: about 24% clay, moderate plasticity when wet. Weak indication
- TopsoilA A sandy clay loam layer about 5 to 18 in down: about 25% clay, moderate plasticity when wet. Possible
- TopsoilABbest layer A sandy clay loam layer about 18 to 30 in down: about 27% clay, moderate plasticity when wet. Promising
- Clay subsoilBt1 A gravelly clay loam layer about 30 to 45 in down: about 33% clay, high plasticity when wet. Possible
- Clay subsoilBt2 A gravelly sandy clay loam layer about 45 to 51 in down: about 31% clay, high plasticity when wet. Possible
- Loamy layerC A very gravelly sandy clay loam layer about 51 to 59 in down: about 28% clay, moderate plasticity when wet. Weak indication
What it looks like raw
The topsoil (AB), 18 to 30 in down in the typical profile: slightly hard, very friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from metamorphic and sedimentary rock and/or alluvium derived from metavolcanics.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in California, in these survey areas: Santa Clara Area, California, Western Part.
By state: wild clay in California.
USDA, distribution and extent: These soils are extensive and are mapped in the Santa Clara Valley. Major Land Resource Area: 14 -- Central California Coastal Valleys
USDA, geographic setting: Flaskan soils are on alluvial fan remnants. Slopes are 0 to 30 percent. These soils formed on material weathered from mixed sources. Elevation is 40 to 300 feet. Mean annual precipitation is 14 to 24 inches. The mean annual temperature is 60 to 62 degrees F. Frost free season is 275 to 325 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alo: Strong lead
- Diablo: Strong lead
- Santerhill: Promising
- Alumrock: Possible
- Katykat: Possible
- Mouser: Possible
- Unistan: Possible
- Ben Lomond: Weak indication
See it on the map
Open a Flaskan spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Flaskan sandy clay loam, 0 to 2 percent slopes, map unit 144 in Santa Clara Area, California, Western Part.
- Official Series Description: Flaskan(revised 10/2009), established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.