Ben Lomond soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ben Lomond shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ben Lomond soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ben Lomond spot on the map
Rated from the USDA soil survey record for Ben Lomond gravelly sandy loam, 15 to 30 percent slopes (Santa Clara Area, California, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 20 in (50 cm)).
- Note Typically starts about 28 in (70 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA1 A gravelly sandy loam layer about 1 to 6 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A sandy loam layer about 6 to 13 in down: about 15% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw A sandy loam layer about 13 to 28 in down: about 17% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerBCbest layer A gravelly sandy loam layer about 28 to 47 in down: about 18% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- BedrockCr Bedrock about 47 to 51 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (BC), 28 to 47 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3)moist; slightly hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 47 in (120 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in California, in these survey areas: Santa Clara Area, California, Western Part.
By state: wild clay in California.
USDA, distribution and extent: Central part of the Coast Range of California. They are not extensive. MLRA 4B.
USDA, geographic setting: Ben Lomond soils are on uplands and have slopes of 5 to 75 percent. They formed in material weathered from sandstone, granodiorite, and quartz diorite at elevations from 400 to 3,000 feet. The climate is coastal Mediterranean having warm, dry but foggy summers and cool, moist winters. The mean annual precipitation is 35 to 60 inches. The average January temperature is about 45 degrees F.; the average July temperature is about 65 degrees F.; and the mean annual temperature is 54 to 57 degrees F. The average January-July temperature difference is about 20 degrees F. The frost free season is 220 to 240 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alo: Strong lead
- Diablo: Strong lead
- Flaskan: Promising
- Santerhill: Promising
- Alumrock: Possible
- Katykat: Possible
- Mouser: Possible
- Unistan: Possible
See it on the map
Open a Ben Lomond spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ben Lomond gravelly sandy loam, 15 to 30 percent slopes, map unit 516 in Santa Clara Area, California, Western Part.
- Official Series Description: Ben Lomond(revised 09/2025), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Pachic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.