Diablo soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 39 to 53 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Diablo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Diablo clay, 15 to 30 percent slopes, MLRA 15 (Santa Clara Area, California, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 52% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (38): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 9.4%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA1 A clay layer about 0 to 5 in down: about 52% clay, high plasticity when wet, dark gray when moist. Promising
- Clay-rich layerA2 A clay layer about 5 to 18 in down: about 52% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layerBkss1 A clay layer about 18 to 30 in down: about 52% clay, high plasticity when wet, finely mixed gray when moist. Strong lead
- Clay-rich layerBkss2 A clay layer about 30 to 39 in down: about 52% clay, high plasticity when wet, finely mixed gray when moist. Strong lead
- Clay-rich layerCkbest layer A clay layer about 39 to 53 in down: about 52% clay, high plasticity when wet, fine and medium mottled appearing olive gray when moist. Strong lead
- BedrockCr Bedrock about 53 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (Ck), 39 to 53 in down in the typical profile: fine and medium mottled appearing olive gray (5Y 5/2), and light olive gray (5Y 6/2), olive gray (5Y 5/2), and olive gray (5Y 4/2) moist; very hard, very firm, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from calcareous shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 53 in (135 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in California, in these survey areas: Santa Clara Area, California, Western Part.
By state: wild clay in California.
USDA, distribution and extent: Soils are extensive in central and southern Coast Ranges of California.
USDA, geographic setting: Diablo soils are on complex undulating, rolling to steep uplands with slopes of 5 to 50 percent. Elevations are 25 to 3,000 feet. These soils formed in residuum weathered from shale, sandstone, and consolidated sediments with minor areas of tuffaceous material. The climate is dry subhumid mesothermal with warm, dry summers and cool, moist winters. The mean annual precipitation is 10 to 35 inches. The average January temperature is 45 to 53 degrees F.; the average July temperature is 65 to 75 degrees F.; and the mean annual temperature is about 57 to 62 degrees F. The average frost free season is about 220 to 320 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alo: Strong lead
- Flaskan: Promising
- Santerhill: Promising
- Alumrock: Possible
- Katykat: Possible
- Mouser: Possible
- Unistan: Possible
- Ben Lomond: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Diablo clay, 15 to 30 percent slopes, MLRA 15, map unit 310 in Santa Clara Area, California, Western Part.
- Official Series Description: Diablo(revised 06/2017), established.
- Taxonomic class: Fine, smectitic, thermic Aridic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.