Alumrock soil
Wild-clay potential
Possible
Possible: a surface layer with some clay typically about 12 to 19 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Alumrock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Alumrock spot on the map
Rated from the USDA soil survey record for Zeppelin-Alumrock complex, 30 to 50 percent slopes (Santa Clara Area, California, Western Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 7 in (19 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 1% by volume).
- Note Surface layer; expect roots and organic matter.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA A fine sandy loam layer about 1 to 5 in down: about 14% clay, moderate plasticity when wet. Weak indication
- TopsoilABt1 A fine sandy loam layer about 5 to 12 in down: about 19% clay, moderate plasticity when wet. Possible
- TopsoilABt2best layer A sandy clay loam layer about 12 to 19 in down: about 22% clay, moderate plasticity when wet. Possible
- Clay subsoilBt1 A sandy clay loam layer about 19 to 26 in down: about 23% clay, moderate plasticity when wet. Possible
- Clay subsoilBt2 A sandy clay loam layer about 26 to 30 in down: about 25% clay, moderate plasticity when wet. Weak indication
- BedrockCr Bedrock about 30 to 31 in down: no clay layer to dig. Weak indication
What it looks like raw
The topsoil (ABt2), 12 to 19 in down in the typical profile: slightly hard, very friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in California, in these survey areas: Santa Clara Area, California, Western Part.
By state: wild clay in California.
USDA, distribution and extent: The soils are inextensive and are mapped in Santa Clara County
USDA, geographic setting: Alumrock soils are on hills. Slopes are 9 to 50 percent. These soils formed in residuum weathered from sandstone. Elevation is 300 to 800 feet. Mean annual precipitation is 20 to 22 inches. The mean annual temperature is 60 to 64 degrees F. Frost free season is 275 to 325 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alo: Strong lead
- Diablo: Strong lead
- Flaskan: Promising
- Santerhill: Promising
- Katykat: Possible
- Mouser: Possible
- Unistan: Possible
- Ben Lomond: Weak indication
See it on the map
Open a Alumrock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Zeppelin-Alumrock complex, 30 to 50 percent slopes, map unit 376 in Santa Clara Area, California, Western Part.
- Official Series Description: Alumrock(revised 11/2009), established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Pachic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.