Durham soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 36 to 42 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Durham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Durham sandy loam, 2 to 6 percent slopes (Cobb County, Georgia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 6 in (16 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 16 in down: about 13% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2 A sandy clay loam layer about 16 to 36 in down: about 27% clay, moderate plasticity when wet, strong brown when moist. Possible
- Loamy layerH3best layer A sandy clay loam layer about 36 to 42 in down: about 30% clay, high plasticity when wet, yellowish red when moist. Promising
- Loamy layerH4 A sandy loam layer about 42 to 48 in down: about 19% clay, low plasticity when wet, yellowish red when moist. Weak indication
- Loamy layerH5 A sandy loam layer about 48 to 60 in down: about 18% clay, low plasticity when wet, yellowish red when moist. Weak indication
What it looks like raw
The loamy layer (H3), 36 to 42 in down in the typical profile: yellowish red (5YR 5/8); firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Georgia, in these survey areas: Cobb County, Georgia.
By state: wild clay in Georgia.
USDA, distribution and extent: Distribution: North Carolina, Alabama, Georgia, South Carolina, and Virginia. Extent: Moderate
USDA, geographic setting: Landscape: Piedmont uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Gwinnett: Strong lead
- Helena: Strong lead
- Hiwassee: Strong lead
- Louisa: Strong lead
- Madison: Strong lead
- Pacolet: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Durham sandy loam, 2 to 6 percent slopes, map unit DiB in Cobb County, Georgia.
- Official Series Description: Durham(revised 11/2025), established.
- Taxonomic class: Fine-loamy, siliceous, semiactive, thermic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.