Comus soil
Wild-clay potential
Weak indication
Weak indication: no layer of Comus shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Comus soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Comus loam, 0 to 2 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (7).
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- Sandy layerH1 A loam layer about 0 to 10 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 A loam layer about 10 to 39 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A sandy loam layer about 39 to 70 in down: about 15% clay, moderate plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 39 to 70 in down in the typical profile: strong brown (7.5YR 5/6); very friable. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 9 map units in Delaware, Maryland, Pennsylvania, Virginia, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Chester County, Pennsylvania; Culpeper County, Virginia; Delaware County, Pennsylvania; Harford County Area, Maryland; Lancaster County, Pennsylvania; New Castle County, Delaware; Prince William County, Virginia.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in Pennsylvania,wild clay in Virginia.
USDA, distribution and extent: Pennsylvania, Maryland, Delaware, and Virginia. The series is of moderate extent.
USDA, geographic setting: Comus soils are on floodplains in the northern Atlantic Coastal Plain and the mesic Southern Piedmont. Slopes range from 0 to 8 percent. Comus soils formed in recent alluvium containing moderate to large amounts of mica. The climate is temperate and humid. The mean annual temperature ranges from 45 to 55 degrees F., and mean annual precipitation is about 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Christiana: Strong lead
- Jackland: Strong lead
- Talleyville: Strong lead
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Comus loam, 0 to 2 percent slopes, map unit 15A in Prince William County, Virginia.
- Official Series Description: Comus(revised 12/2015), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Fluventic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.