Calouse soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 32 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Calouse soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Calouse spot on the map
Rated from the USDA soil survey record for Calouse silt loam, 3 to 7 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 25% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 15 in down: about 18% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2 A silt loam layer about 15 to 32 in down: about 21% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH3best layer A silt loam layer about 32 to 60 in down: about 21% clay, moderate plasticity when wet, pale brown when moist. Possible
What it looks like raw
The loamy layer (H3), 32 to 60 in down in the typical profile: pale brown (10YR 6/3), dark brown (10YR 4/3) moist; very hard, very firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess with some volcanic ash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Idaho, Washington, in these survey areas: Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Southwestern Washington, northeastern Oregon, and northern Idaho in the loess areas. The series is of moderate extent.
USDA, geographic setting: These soils are at elevations of 1,500 to 2,700 feet on undulating to hilly uplands in a continental temperate climate having an annual precipitation of 15 to 18 inches with relatively dry summers and cool moist winters. The mean January temperature is 28 degrees F., mean July temperature is 68 degrees F., and mean annual temperature is 48 degrees F. The average frost-free season is 120 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cramont: Strong lead
- Garfield: Strong lead
- Konert: Strong lead
- Latah: Strong lead
- Taney: Strong lead
- Tilma: Strong lead
- Caldwell: Promising
- Naff: Promising
See it on the map
Open a Calouse spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Calouse silt loam, 3 to 7 percent slopes, map unit 21 in Whitman County, Washington.
- Official Series Description: Calouse(revised 10/2002), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Calcic Pachic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.