Blackoar soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 11 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Blackoar soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Blackoar spot on the map
Rated from the USDA soil survey record for Blackoar silt loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Missouri) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (13).
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 11 in down: about 26% clay, moderate plasticity when wet, very dark gray when moist. Possible
- Loamy layerBgbest layer A silt loam layer about 11 to 48 in down: about 20% clay, moderate plasticity when wet, stratified gray when moist. Possible
- Loamy layerBCg A silt loam layer about 48 to 60 in down: about 26% clay, moderate plasticity when wet, stratified gray when moist. Weak indication
What it looks like raw
The loamy layer (Bg), 11 to 48 in down in the typical profile: stratified gray (10YR 5/1), and dark gray (10YR 4/1); silt loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Missouri, in these survey areas: Pike County, Missouri.
By state: wild clay in Missouri.
USDA, distribution and extent: West-central and northern Missouri and Illinois. The series is of large extent.
USDA, geographic setting: Blackoar soils are on nearly level flood plains. Slopes range from 0 to 2 percent. The soils formed in silty alluvium. The mean annual temperature ranges from 49 to 56 degrees F, and mean annual precipitation ranges from 32 to 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bremer: Strong lead
- Bucklick: Strong lead
- Carlow: Strong lead
- Chequest: Strong lead
- Crider: Strong lead
- Dupo: Strong lead
- Gorin: Strong lead
- Keswick: Strong lead
See it on the map
Open a Blackoar spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Blackoar silt loam, 0 to 2 percent slopes, occasionally flooded, map unit 13505 in Pike County, Missouri.
- Official Series Description: Blackoar(revised 07/2007), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Fluvaquentic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.