Belknap soil
Wild-clay potential
Weak indication
Weak indication: no layer of Belknap shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Belknap soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Belknap spot on the map
Rated from the USDA soil survey record for Belknap silt loam, 0 to 2 percent slopes, occasionally flooded (Pike County, Missouri) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 52 in (132 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerBwbest layer A silt loam layer about 7 to 59 in down: about 16% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerBg A silt loam layer about 59 to 79 in down: about 11% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (Bw), 7 to 59 in down in the typical profile: brown (10YR 5/3); friable. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Missouri, in these survey areas: Pike County, Missouri.
By state: wild clay in Missouri.
USDA, distribution and extent: MLRAs 113, 114A, 114B, 115A, 115B, 115C, 120A, and 120B in Illinois, Indiana, Missouri, and Kentucky. The series is of large extent.
USDA, geographic setting: Belknap soils are on flood plains. Slope ranges from 0 to 3 percent. Belknap soils formed in acid, silty alluvium. Mean annual precipitation ranges from 965 to 1295 mm (38 to 51inches). Mean annual temperature ranges from 10 to 15 degrees C (51 to 59 degrees F). Frost-free period is 161 to 200 days. Elevation is 104 to 213 meters (340 to 700 feet) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bremer: Strong lead
- Bucklick: Strong lead
- Carlow: Strong lead
- Chequest: Strong lead
- Crider: Strong lead
- Dupo: Strong lead
- Gorin: Strong lead
- Keswick: Strong lead
See it on the map
Open a Belknap spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Belknap silt loam, 0 to 2 percent slopes, occasionally flooded, map unit 66058 in Pike County, Missouri.
- Official Series Description: Belknap(revised 01/2013), established.
- Taxonomic class: Coarse-silty, mixed, active, acid, mesic Fluventic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.