Bahem soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bahem shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bahem soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bahem silt loam, 0 to 1 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Note Moderate engineering plasticity index (9).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 14% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerBkbest layer A silt loam layer about 7 to 34 in down: about 14% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerC A very fine sandy loam layer about 34 to 60 in down: about 5% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (Bk), 7 to 34 in down in the typical profile: light gray (10YR 7/2), dark grayish brown (10YR 4/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium and/or loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Idaho, in these survey areas: Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southern Idaho. The series is moderately extensive.
USDA, geographic setting: Bahem soils are on terraces, basalt plains, buttes, and hillsides. Slopes range from 0 to 50 percent and are dominantly less than 8 percent. They formed in loess or silty alluvium. Elevation ranges from 2,000 to 5,000 feet. The average annual precipitation ranges from 7 to 12 inches, and the average annual temperature ranges from 46 to 52 degrees F. The frost-free period is about 100 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Catherine: Promising
- Elijah: Promising
- Greenleaf: Promising
- Nannyton: Promising
- Baldock: Possible
- Chance: Possible
- Draper: Possible
- Harpt: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bahem silt loam, 0 to 1 percent slopes, map unit BaA in Canyon Area, Idaho.
- Official Series Description: Bahem, established.
- Taxonomic class: Coarse-silty, mixed, superactive, mesic Xeric Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.