Warne soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 7 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Warne soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Warne loam, 0 to 2 percent slopes, occasionally flooded (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 53% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (35): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilA A loam layer about 0 to 4 in down: about 19% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerE A loam layer about 4 to 7 in down: about 19% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 7 to 48 in down: about 53% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- Clay subsoilBtg A clay loam layer about 48 to 80 in down: about 36% clay, moderate plasticity when wet, gray when moist. Promising
What it looks like raw
The clay subsoil (Bt), 7 to 48 in down in the typical profile: light yellowish brown (2.5Y 6/4); friable; slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: old clayey alluvium derived from igneous and metamorphic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in North Carolina, in these survey areas: Davidson County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: North Carolina and Virginia and possibly South Carolina, Georgia, and Alabama.
USDA, geographic setting: Landscape: Piedmont and Upper Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Armenia: Strong lead
- Badin: Strong lead
- Casville: Strong lead
- Cecil: Strong lead
- Clifford: Strong lead
- Davidson: Strong lead
- Davie: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Warne loam, 0 to 2 percent slopes, occasionally flooded, map unit WaA in Davidson County, North Carolina.
- Official Series Description: Warne(revised 01/2026), established.
- Taxonomic class: Fine, mixed, semiactive, thermic Aeric Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.