Tetotum soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 9 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Tetotum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Tetotum spot on the map
Rated from the USDA soil survey record for Tetotum fine sandy loam, 0 to 2 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 9 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2best layer A clay loam layer about 9 to 48 in down: about 28% clay, moderate plasticity when wet, gray when moist. Promising
- Sandy layerH3 A fine sandy loam layer about 48 to 72 in down: about 18% clay, moderate plasticity when wet, gray when moist. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 48 in down in the typical profile: gray (10YR 6/1); firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy marine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Virginia, in these survey areas: Prince William County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Distribution: Virginia, North Carolina, and possibly Alabama, and Georgia
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Susquehanna: Strong lead
- Worsham: Strong lead
- Aden: Strong lead
- Albano: Strong lead
- Bladen: Strong lead
See it on the map
Open a Tetotum spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Tetotum fine sandy loam, 0 to 2 percent slopes, map unit TeA in Stafford and King George Counties, Virginia.
- Official Series Description: Tetotum(revised 05/2004), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, thermic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.