Stumptown soil
Wild-clay potential
Weak indication
Weak indication: no layer of Stumptown shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Stumptown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Stumptown spot on the map
Rated from the USDA soil survey record for Stumptown very flaggy loam, 25 to 50 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 19% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 12 in (30 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Loamy layerH1best layer A very flaggy loam layer about 0 to 12 in down: about 19% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2 A very flaggy clay loam layer about 12 to 20 in down: about 27% clay, moderate plasticity when wet, brownish yellow when moist. Weak indication
- Loamy layerH3 An extremely flaggy sandy loam layer about 20 to 27 in down: about 19% clay, low plasticity when wet, brownish yellow when moist. Weak indication
- BedrockH4 Bedrock about 27 to 33 in down: no clay layer to dig. Weak indication
- BedrockH5 Bedrock about 33 to 43 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H1), 0 to 12 in down in the typical profile: light yellowish brown (10YR 6/4); very friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from mica schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 33 in (84 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Prince William County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia, Maryland, and southern Pennsylvania. Moderate extent; 5,000 acres in northern Virginia.
USDA, geographic setting: Stumptown soils are on ridges, ridge points and convex sideslopes of the Northern portion of the Blue Ridge Anticlinorium. These soils developed partly in local creep and partly in residuum that weathered from interbedded quartzite and quartz muscovite schist. Slope ranges from 2 to 50 percent. Mean annual precipitation ranges from 36 to 44 inches and mean annual temperature ranges from 50 to 59 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Braddock: Strong lead
- Buckhall: Strong lead
- Calverton: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
See it on the map
Open a Stumptown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Stumptown very flaggy loam, 25 to 50 percent slopes, map unit 51E in Prince William County, Virginia.
- Official Series Description: Stumptown(revised 02/2022), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Inceptic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.