Buckhall soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 12 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Buckhall soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Buckhall spot on the map
Rated from the USDA soil survey record for Buckhall loam, 2 to 7 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 7 in down: about 19% clay, moderate plasticity when wet, light yellowish brown when moist. Possible
- Loamy layerH2 A clay loam layer about 7 to 12 in down: about 28% clay, moderate plasticity when wet, brownish yellow when moist. Possible
- Clay-rich layerH3best layer A clay layer about 12 to 43 in down: about 48% clay, high plasticity when wet, strong brown when moist. Strong lead
- Loamy layerH4 A sandy loam layer about 43 to 72 in down: about 18% clay, moderate plasticity when wet, reddish yellow when moist. Possible
What it looks like raw
The clay-rich layer (H3), 12 to 43 in down in the typical profile: strong brown (7.5YR 5/6); firm, plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from mica schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: clayey.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Virginia, in these survey areas: Prince William County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia and Maryland. The series is of moderate extent.
USDA, geographic setting: Buckhall soils are on ridgetops and side slopes of the Northern Piedmont Plateau. Slope gradients range from 0 to 25 percent. These soils developed in residuum that weathered from granite, gneiss and schist. Mean
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Braddock: Strong lead
- Calverton: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Jackland: Strong lead
See it on the map
Open a Buckhall spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Buckhall loam, 2 to 7 percent slopes, map unit 10B in Prince William County, Virginia.
- Official Series Description: Buckhall(revised 02/2022), established.
- Taxonomic class: Fine, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.