Calverton soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 29 to 55 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Calverton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Calverton spot on the map
Rated from the USDA soil survey record for Calverton silt loam, 0 to 7 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 40% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 19% clay, moderate plasticity when wet. Possible
- Loamy layerH2 A silty clay loam layer about 10 to 19 in down: about 30% clay, moderate plasticity when wet. Promising
- Loamy layerH3 A silt loam layer about 19 to 29 in down: about 25% clay, moderate plasticity when wet, common fine and medium strong brown when moist. Possible
- Clay-rich layerH4best layer A silty clay layer about 29 to 55 in down: about 40% clay, high plasticity when wet, red when moist. Strong lead
- BedrockH5 Bedrock about 55 to 65 in down: no clay layer to dig. Weak indication
- BedrockH6 Bedrock about 65 to 75 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H4), 29 to 55 in down in the typical profile: red (2.5Y 4/8); firm, plastic, sticky. Raw colour is not fired colour.
About the soil
- Parent material: Triassic residuum.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 65 in (165 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Prince William County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia, Pennsylvania, and possibly Maryland in the Triassic lowlands of the Piedmont Plateau. The series is of moderate extent.
USDA, geographic setting: Calverton soils are nearly level to gently sloping soils typically on flats, low ridges, saddles, and depressions. Slopes range from 0 to 7 percent. They formed in material weathered from shale, siltstone, and some sandstone (Triassic Age). The mean annual precipitation ranges from about 37 to 43 inches and the mean annual temperature ranges from about 50 to 57 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Braddock: Strong lead
- Buckhall: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Jackland: Strong lead
See it on the map
Open a Calverton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Calverton silt loam, 0 to 7 percent slopes, map unit 11B in Prince William County, Virginia.
- Official Series Description: Calverton(revised 12/2005), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Aquic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.