Sedgefield soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 16 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sedgefield soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sedgefield spot on the map
Rated from the USDA soil survey record for Sedgefield sandy loam, 2 to 8 percent slopes (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (42.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilAp A sandy loam layer about 0 to 16 in down: about 14% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 16 to 31 in down: about 48% clay, high plasticity when wet, brownish yellow when moist. Strong lead
- Loamy layerBC A clay loam layer about 31 to 34 in down: about 29% clay, moderate plasticity when wet, strong brown when moist. Possible
- Loamy layerC A loam layer about 34 to 80 in down: about 25% clay, moderate plasticity when wet, mottled light gray when moist. Possible
What it looks like raw
The clay subsoil (Bt), 16 to 31 in down in the typical profile: brownish yellow (10YR 6/6); firm; sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: saprolite derived from diorite and/or gabbro and/or diabase and/or gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in North Carolina, in these survey areas: Davidson County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: Distribution: Georgia, North Carolina, and Virginia.
USDA, geographic setting: Landscape: Piedmont
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Armenia: Strong lead
- Badin: Strong lead
- Casville: Strong lead
- Cecil: Strong lead
- Clifford: Strong lead
- Davidson: Strong lead
- Davie: Strong lead
See it on the map
Open a Sedgefield spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sedgefield sandy loam, 2 to 8 percent slopes, map unit SfB in Davidson County, North Carolina.
- Official Series Description: Sedgefield(revised 11/2017), established.
- Taxonomic class: Fine, mixed, active, thermic Aquultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.