Occoquan soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 9 to 17 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Occoquan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Occoquan spot on the map
Rated from the USDA soil survey record for Occoquan sandy loam, 7 to 25 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note Moderate thickness (about 8 in (20 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 9 in down: about 13% clay, low plasticity when wet, pale brown when moist. Weak indication
- Loamy layerH2best layer A loam layer about 9 to 17 in down: about 27% clay, moderate plasticity when wet, strong brown when moist. Possible
- Sandy layerH3 A sandy loam layer about 17 to 53 in down: about 16% clay, low plasticity when wet, strong brown when moist. Weak indication
- BedrockH4 Bedrock about 53 to 57 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 17 in down in the typical profile: strong brown (7.5YR 5/8); friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from granite and gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 53 in (135 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Virginia, in these survey areas: Prince William County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia and Maryland. Large extent.
USDA, geographic setting: Occoquan soils are on summits, shoulders, and sideslopes of narrow ridges in the Northern part of the Piedmont Plateau. Slope gradients ranges from 0 to 50 percent. These soils are underlain by granite gneiss and schist. Mean annual precipitation ranges from 36 to 44 inches and mean annual temperature ranges from 50 to 57 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Braddock: Strong lead
- Buckhall: Strong lead
- Calverton: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
See it on the map
Open a Occoquan spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Occoquan sandy loam, 7 to 25 percent slopes, map unit 44D in Prince William County, Virginia.
- Official Series Description: Occoquan(revised 01/2022), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Inceptic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.